American Wire Guards
Phone: 800-328-8996
Guard Finder
Height (in)
 Width (in)
 Depth (in)
 Extra Tolerance
Guard Builder
Guards are usually mounted to a wall. If you have special instructions regarding your guard, the drawing illustrates what we consider height, width, depth, front and top.
Measuring your existing guard
1 Guard


Guard

Measure the inside dimension of the wires to
ensure full clearance of the object being covered.
Note

You may be required to rotate your guard to fit your object. Height and width are interchangeable on nearly all of our guards. Guards with a conduit spacer can still be rotated but may not fit over your conduit.

 Rotate
Measuring your object
1 Exit Sample

Measure your Height and width and depth of your object.
These are the dimenisons you will enter in to the "Height,
Width, Depth" section of the Guard Finder.
2 Extra Tolerance

Remember that you'll need to allow for some clearance
around your object. This padding can vary from an one inch
up to 6 inches depending on the size of your guard.
Enter your desired padding in the Guard Finder.
Note

You may be required to rotate your guard to fit your object. Height and width are interchangeable on nearly all of our guards. Guards with a conduit spacer can still be rotated but may not fit over your conduit.

 Rotate
American Wire Guards

Customer Service & Technical Support

Toll Free Phone:
1-800-328-8996

Toll Free Fax:
1-800-789-1882

American Time & Signal Co.
ATTN: Wire Guard Division
140 3rd St. So.
PO Box 707
Dassel, MN 55325







American Time & Signal